what is a lan cable and how i make a lan cable

lan cable 

 LAN cable can be any specific type of data cable used in computer networking. It technically refers to any cable that can only be run a short distance including most kinds of Coax and stuff terminated with a BNC or Ethernet Cables.

how i make a lane cable

                        first what you need to make a cable

you need this set 

Step 1: Strip the cable jacket about 1.5 inch down from the end.

Step 2: Spread the four pairs of twisted wire apart. For Cat 5e, you can use the pull string to strip the jacket farther down if you need to, then cut the pull string. Cat 6 cables have a spine that will also need to be cut

Step 3: Untwist the wire pairs and neatly align them in the T568B orientation. Be sure not to untwist them any farther down the cable than where the jacket begins; we want to leave as much of the cable twisted as possible.

.

this is a coding 

like see on this image

AND

Step 4: Cut the wires as straight as possible, about 0.5 inch above the end of the jacket.

Step 5: Carefully insert the wires all the way into the modular connector, making sure that each wire passes through the appropriate guides inside the connector.

Step 6: Push the connector inside the crimping tool and squeeze the crimp all the way down.

like ass 

Step 7: Repeat steps 1-6 for the other end of the cable.

Step 8: To make sure you've successfully terminated each end of the cable, use a cable tester to test each pin.

thanks